2014-2024 Toyota 4Runner Fender Flare Kit Installation Guide
Before the installation, remove the factory front fender flares by removing all the bolts in the wheel well as indicated, and pulling on the fender flares to release all the clips on the back side. Remove mud flaps if equipped.
Front passenger side fender flare shown.
Optional: remove any clips left on the body panels.
Now remove all the bolts and/or push pins in the rear wheel well as indicated. Keep the rear flare on the vehicle.
Remove mud flaps if equipped.
Rear fender flare shown.
Apply two layers of the 3M™ tape to the back side of the fender flares, as shown in the picture. Make sure to peel off the first layer before applying the second layer.
Apply one layer of the 3M™ tape on the rear door flare like indicated in the picture.
Leave the backing of the tape on for now.
We recommend applying adhesion promoter on the back side of the flares as well as on the fender paint before installing the 3M™ tape to help with better adhesion.
Make sure to thoroughly clean the paint with Isopropyl alcohol.
Optimal surface temperature for the 3M™ Super Strength Molding Tape is above 65°F (18°C).
Next, peel off only less than an inch of each end of the tape and leave the backing as shown in the pictures. Then line up each fender flare to the fender, make sure the holes line up correctly.
Loosely install the bolts to help seat the flares into the correct position, before peeling off the backing of the tape and applying even pressure to help bond the fender flares to the body panel.
The fender flares for the rear doors are only held on with tape.
Finally, tighten up all the bolts until snug. DO NOT over-tighten the bolts to prevent damage to the fender flares.
Enjoy the added protection and improved aesthetics to your vehicle!
