2023-Current Toyota Sequoia Rear Recovery Point/Hybrid Bumper Installation Guide
Before the installation, remove the factory rear lower plastic cover, revealing the tow hitch receiver.
The cover is held on with clips, it can be easily pulled off by hand.
First, install the recovery point into the tow hitch receiver tube. Use any 5/8 inch tow hitch pin to secure it.
Hitch pin NOT included in the kit.
Next, Insert a provided M12 bolt through each of the CNC blocks, and set it on top of the trailer safety chain hook up points on each side of the hitch receiver, as shown in the picture.
Finally, slide on the hybrid bumper and secure it with 2 of the provided M12 nuts and washers. Use the provided spacer plates as needed to fine tune the fitment.
Torque them down to 75 ft-lbs./101 Nm.
Enjoy the Recovery Point and the added protection!
