2024-Current Ford Mustang Front Fender Flares Installation Guide
Before the installation, jack up the front of the vehicle for clearance.
Apply the supplied 3M™ Super Strength Molding Tape onto each of the flares like shown in the pictures (front and the top portion). Make sure to thoroughly clean the surface of the flares with isopropyl alcohol, before applying the tape. We recommend cutting the tape in half (thinner) for the front portion of the flares.
Optimal surface temperature for the 3M™ Super Strength Molding Tape is above 65°F (18°C).
Remove 4 push pins from the front of the wheel well liner.
Driver side front fender shown in picture.
Remove the 7mm bolt on the top of the wheel well.
Driver side front fender shown in picture.
Remove 2 push pins from the rear of the wheel well liner.
Driver side front fender shown in picture.
Note that the 4 longer push pins go in the front of the wheel well, and the 2 shorter ones go on the rear.
Now remove the tape backing, and install the flares by lining up all the holes on the flares to the wheel well push pin locations. Start from the front and work your way to the rear.
Reinstall all the hardware removed from the previous steps, and repeat on both sides of the vehicle.
For the polyurethane version, use the provided push pins on the front instead. And use the longer OEM push pins for the rear two holes.
Enjoy the added protection and improved aerodynamics and aesthetics added to your vehicle!
