2024-Current Ford Mustang Splitter Extension Installation Guide

Carbon fiber car part with red markings on a white background.
Close-up of a black carbon fiber car part with a red line indicating a specific area.

Before the installation, jack up the front of the vehicle for clearance.

Apply the supplied 3M™ Super Strength Molding Tape onto the splitter extension in between the 9 outer holes like shown in the pictures. Make sure to thoroughly clean the surface of the splitter extension with isopropyl alcohol, before applying the tape.

Optimal surface temperature for the 3M™ Super Strength Molding Tape is above 65°F (18°C).

Close-up of the interior of a vehicle, showing two black screws circled in red on a dark panel.
Front underside of a black sports car with visible screws circled in red.

Remove the 12 bolts (7mm) underneath the OEM splitter.

Underside of a car with a carbon fiber trim and several small holes, some circled in red.

Remove the tape backing and install the splitter extension by lining up the 12 bolt holes with the OEM splitter and reinstalling the bolts.

Drill small pilot holes with 3/16 inch drill bit into the OEM splitter before installing the provided screws into the outer 9 holes.

Make sure to thoroughly clean the underneath of the OEM splitter with isopropyl alcohol, before installation.

Close-up of a carbon fiber and black plastic interior trim piece on white fabric background.
Car interior part, likely a trim piece, with black sections and slots, resting on a white padded surface with a yellow cloth nearby.

Bumper scrape guards like SLIPLO® (shown in the pictures) are highly recommended to prevent damage to the carbon fiber from scraping on the ground.

Black Ford Mustang sports car parked in a parking lot, showing the front and side view with a modern design.
Black sports car parked outside a warehouse with stacked boxes on metal shelves inside.

Enjoy the improved aerodynamics and aesthetics added to your vehicle!

Not Your Typical On-road Parts